The basin has 3Bohrungen.zulauf, emergency drain, overflow.
I had due to decline in silicone adhesion of the bonds, cut the entire basin to the adhesive seams by cutter blades apart and remove any silicone residues by Acceton.
I signed up for my Neuverklebung for a polymer adhesive branded FIXALL of Soudal.der decided not only far more resilient than is conventional Aqua silicone but also in repair measures successive liable and a connection is received.
Completely solvent free and not Acetic interlacing.
Instead polymerisation by humidity.
Furthermore, I have a 4cm wide safety glass strips installed in each corner vertically over the entire height in front of the matrimonial bond seams, widerum adhesive by polymer.
In order to minimize the pressure of the water column of 70cm on the adhesive seams.
In addition, my pelvis has only longitudinal vines and has no tie rods.
This shortcoming on the part of the aquarium builder and the fact that the longest branches are not even around obstructed forming special each 10cm in front of every corner, led to the pressure, the stress limit of silicon seams quickly erreichte.Um this Error wiederverkleben not to make I've made 10 glass for the corners of my delta basin flush Vollglaszugstreben made all bonded seams together and wurden.Ähnlich fully adhered to the matrimonial longest vines as a base plate.
fine-grained sand from the Kiessee
Special features of the facility:
have my present pool completely against the wall gehangen.Mittels 10 threaded rods M20 I 37cm deep driven into the supporting walls and have locked there by means 2komponenten injection concrete. (NEN have unfortunately completely lopsided Floor).
But besides that, the traffic load of the ceiling for 2,1t to groß.Ich would have anchored 5 piece by the Cabinet each bearing side and sagging Luckily keen problem zwechs.
Am only scaffolders and keen structural engineer.
I chose fine-grained sand as substrate, because I think Sandcichliden and möchte.Als RW are their needs sand justified by to Saien I signed up for various modules of Back to Nature I entschieden.Welche mainly as Overhang Direction Reason glued to the disc. Only the corner module diehnt for receiving and hiding my piping and reaches to the Bodengrund.Mittig I have a module divided and stuck a rock room dividers on the bottom plate.
.Versehen I have the floor rocks with small holes, as. Under the module my water drain befindet.Zum Wasserwechselusw
4 * 80W T5 (2blau 2 white) mitlterweile 3x10W + 2x20W replaced by LED floodlight 6500k cool white
4kammer external filter basin 250liter
Return pump 2200L / h
10 Xenotilapia Nigrolabiata
13 cyprichromis leptosoma Yellowhead
White mosquito, CYCLOPS, Daphne, granules, gelegendlich Lobster Eggs